Martin Fireplaces 2518 Benutzerhandbuch

21

  

Use only the cable included with the Tandem Connection Kit to connect the control-
lers: standard serial cables will not work. Cable wiring is shown below: pins 6 - 9 are
not used or shown. 

Connect the cable to the RS-232 I/O port on each controller.

Connect the XLR cable to the DMX output of the 

bottom

 controller. 

1. Turn off both controllers and connect them as described above.

2. Turn on the bottom controller first. 

3. Turn on the top controller and immediately press and hold the top

3 DMX channel buttons (1-12, 13-24, 25-36) until “ON” is dis-
played. The controllers are now ready for tandem operation.

4. Repeat to return to single mode operation. “OF” is displayed. 

DMX output

72 channels

144 channels

Channel buttons

Control 6 low + 6 high channels.

Control 12 channels.

Channel master

Toggles between low and high 
channels, saves auto-start 
sequence.

Saves auto-start sequence.

Scenes

6 per bank, 181 total.

12 per bank, 361 total. 

Display

Shows bank with 2 digits, scene 
with 1 digit. 

Top shows bank, bottom shows 
scene. 

Arrow buttons

Select bank 1-30. Toggle show 
mode on/off.

Same on top controller only.

MIDI execution

Supported

Not supported

Table 6: Single versus tandem mode

1 2 3 4 5

1 2 3 4 5

5:3#RKP

5:3#RKP