Enterasys Networks X16-C Benutzerhandbuch
Installing and Removing Modules
Matrix X16-C Chassis Installation Guide 3-23
Installing and Removing CMs
1.
Locate the empty CM1 slot, and position the module in the guide rail at the left of the slot, as
shown in
shown in
. Gently insert the module until it engages with the backplane
connectors. Be sure the ejector handles are open as shown in
.
2.
, engaging
the lip of the slot, until the module locks into place and is flush with adjoining coverplates.
3.
Tighten the two captive screws.
4.
After completing all module installation, be sure that you leave no slots uncovered. Failure to
seal any empty slots with the provided coverplates may hamper power cooling of the chassis
and its components.
seal any empty slots with the provided coverplates may hamper power cooling of the chassis
and its components.
5.
To remove an installed CM, first disconnect any cabling and perform the installation steps in
reverse.
reverse.
Figure 3-22 Installing Control Module
Note: If you ordered the Memory Upgrade Kit (X-4G-MEM), install the DIMMs first. For installation
instructions, refer to “
instructions, refer to “
1 Control Module slot 1
3 Guide rails
5 Captive screws (2)
2 Control Module
4 Ejector handles (2)
5
1
2
3
6
7
8
4
5
FAN TRAY
2
FAN TRAY
3
1
FAN TRAY
STRAP
S/N:
MAC ADD.
CM1
CM2
GROUND
STATUS
ACTIVE/
STANDBY
RESET
USB
ETHERNET
COM
TX
RX
TX
RX
TX
RX
TX
RX
5
1
3
3
2
5
4
4