Juniper Networks M10i Benutzerhandbuch
Figure 31: Removing a Routing Engine
Figure 32: Removing an HCM
Installing an HCM
):
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
connect the strap to one of the ESD points on the chassis. Make sure the router
is attached to a proper earth ground. For more information about ESD, see
2.
Place one hand under the HCM to support it and grasp the handle on the faceplate
with the other hand.
with the other hand.
3.
Align the rear of the HCM with the guide rails inside the chassis and slide it in
completely.
completely.
CAUTION: Align the HCM carefully with the guide rails and push it in evenly. Damage
can result if it gets lodged in the rails because of uneven movement.
can result if it gets lodged in the rails because of uneven movement.
4.
Place one hand under the Routing Engine to support it and grasp the handle on
the faceplate with the other hand.
the faceplate with the other hand.
Replacing an HCM
■
95
Chapter 13: Replacing Hardware Components