Juniper Networks M10i Benutzerhandbuch

9.

Use one of the following methods to bring the PIC online:

■

Press and hold the PIC offline button until the status LED on the PIC faceplate
indicates normal functioning, which usually takes about 5 seconds. The LED
is usually green; for more information, see the M10i Internet Router PIC Guide.
The offline button for each PIC is located on the HCM and is labeled with
the PIC slot number. The PICs in FPC 

0

 are located on the upper HCM, and

the PICs installed in FPC 

1

 are located on the lower HCM.

■

Issue the following CLI command:

user@host>request chassis pic fpc-slot fpc-slot pic-slot pic-slot online

For more information about the command, see the JUNOS System Basics and
Services Command Reference.

The normal functioning status LED confirms that the PIC is online. You can also
verify correct PIC functioning by issuing the 

show chassis fpc pic-status

 command

Figure 36: Installing a PIC

Replacing PIC Cables

Removing and installing PIC cables does not affect router function, except that a PIC
does not receive or transmit data while its cable is disconnected. To replace a PIC
cable, perform the following procedures:

■

■

To remove a PIC cable, follow this procedure:

Replacing PIC Cables

■

101

Chapter 13: Replacing Hardware Components