Juniper Networks M10i Benutzerhandbuch
Chapter 6
Unpacking the Router
This chapter explains how to unpack the router and verify the parts received. It also
describes how to move the mounting brackets and install the cable management
system. Before beginning, prepare the installation site as described in
describes how to move the mounting brackets and install the cable management
system. Before beginning, prepare the installation site as described in
on page 41 and review the safety information in
on page 135, especially
This chapter discusses the following topics:
■
■
Tools and Parts Required
To unpack the router and prepare for installation, you need the following tools:
■
Utility knife for cutting the sealing tape on the shipping carton
■
Phillips (+) screwdriver, number 2
Unpacking the Router
The router is shipped in a cardboard carton, held in place with foam packing material.
The crate also contains an accessory box, the front-mounting shelf, and the M10i
Internet Router Installation Quick Start.
The crate also contains an accessory box, the front-mounting shelf, and the M10i
Internet Router Installation Quick Start.
NOTE: The router is maximally protected inside the shipping carton. Do not unpack
it until you are ready to begin installation.
it until you are ready to begin installation.
To unpack the router, perform these steps:
1.
Move the shipping carton to a staging area as close to the installation site as
possible.
possible.
2.
Position the carton so that the arrows are pointing up.
3.
Using a utility knife, cut through the sealing tape on the top seam of the carton.
Open the top flaps of the carton.
Open the top flaps of the carton.
Tools and Parts Required
■
47