TP-LINK TL-WR841ND Benutzerhandbuch

TL-WR841N/TL-WR841ND/TL-WR847N

 

- 22 - 

Step 3:  The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected Setup 

process.  

Step 4:  When the WPS LED is on, the client device has successfully connected to the Router.   
Step 5:  Refer back to your client device or its documentation for further instructions.   

II.  Enter the client device’s PIN on the Router 
Use this method if your client device has a Wi-Fi Protected Setup PIN number. 

Step 1:  Keep the default WPS Status as Enabled and click the Add Device button in Figure 4-2, 

then the following screen will appear.   

Figure 4-4  Add A New Device 

Step 2:  Enter the PIN number from the client device in the field on the above WPS screen. Then 

click Connect button. 

Step 3:  “Connect successfully” will appear on the screen of Figure 4-4, which means the client 

device has successfully connected to the Router. 

Use this method if your client device asks for the Router’s PIN number.   
Step 1:  On the client device, enter the PIN number listed on the Router’s Wi-Fi Protected Setup 

screen. (It is also labeled on the bottom of the Router.) 

Step 2:  The Wi-Fi Protected Setup LED flashes for two minutes during the Wi-Fi Protected 

Setup process.   

Step 3:  When the WPS LED is on, the client device has successfully connected to the Router.   
Step 4:  Refer back to your client device or its documentation for further instructions.   



 

1)  The WPS LED on the Router will light green for five minutes if the device has been 

successfully added to the network. 

2)  The WPS function cannot be configured if the Wireless Function of the Router is disabled. 

Please make sure the Wireless Function is enabled before configuring the WPS. 

 

Figure 4-5  the Network menu 

There are three submenus under the Network menu (shown in Figure 4-5): LAN, WAN and MAC 
Clone. Click any of them, and you will be able to configure the corresponding function.