ZyXEL Communications nbg-418n Benutzerhandbuch
Chapter 6 Wireless LAN
NBG-418N User’s Guide
80
6.9 WPS Station Screen
Use this screen when you want to add a wireless station using WPS. To open this screen, click
Network > Wireless LAN > WPS Station tab.
Network > Wireless LAN > WPS Station tab.
Note: Note: After you click Push Button on this screen, you have to press a similar
button in the wireless station utility within 2 minutes. To add the second wireless
station, you have to press these buttons on both device and the wireless station
again after the first 2 minutes.
Figure 58
Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
Release
Configuration
Configuration
This button is only available when the WPS status displays Configured.
Click this button to remove all configured wireless and wireless security settings for WPS
connections on the NBG-418N.
connections on the NBG-418N.
Apply
Click Apply to save your changes back to the NBG-418N.
Refresh
Click Refresh to get this screen information afresh.
Table 33
Network > Wireless LAN > WPS (continued)
LABEL
DESCRIPTION
Table 34
Network > Wireless LAN > WPS Station
LABEL
DESCRIPTION
Push Button
Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations’s wireless settings. See
wireless stations’s wireless settings. See
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
information synchronization.
Or input station’s
PIN number
PIN number
Use this button when you use the PIN Configuration method to configure wireless station’s
wireless settings. See
wireless settings. See
Type the same PIN number generated in the wireless station’s utility. Then click Start to
associate to each other and perform the wireless security information synchronization.
associate to each other and perform the wireless security information synchronization.