ZyXEL Communications nbg-418n User Manual

Chapter 6 Wireless LAN

NBG-418N User’s Guide

Use this screen when you want to add a wireless station using WPS. To open this screen, click 
Network > Wireless LAN > WPS Station tab.

Note: Note: After you click Push Button on this screen, you have to press a similar 

button in the wireless station utility within 2 minutes. To add the second wireless 

station, you have to press these buttons on both device and the wireless station 

again after the first 2 minutes.

Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

Release 
Configuration

This button is only available when the WPS status displays Configured.

Click this button to remove all configured wireless and wireless security settings for WPS 
connections on the NBG-418N.

Apply

Click Apply to save your changes back to the NBG-418N.

Refresh

Click Refresh to get this screen information afresh.

Network > Wireless LAN > WPS (continued)

Network > Wireless LAN > WPS Station

Push Button

Use this button when you use the PBC (Push Button Configuration) method to configure 
wireless stations’s wireless settings. See 

Click this to start WPS-aware wireless station scanning and the wireless security 
information synchronization. 

Or input station’s 
PIN number

Use this button when you use the PIN Configuration method to configure wireless station’s 
wireless settings. See 

Type the same PIN number generated in the wireless station’s utility. Then click Start to 
associate to each other and perform the wireless security information synchronization.