ZyXEL Communications P-793H Benutzerhandbuch
Chapter 15 Remote Management Configuration
P-793H User’s Guide
201
15.6.3 Configuring SNMP
See
for background information. Use this screen to change your
ZyXEL Device’s SNMP settings. Click Advanced > Remote MGMT > SNMP. The screen
appears as shown.
appears as shown.
Figure 104 Remote MGMT > SNMP
The following table describes the labels in this screen.
Table 76 Remote MGMT > SNMP
LABEL
DESCRIPTION
SNMP
Port
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
Access Status
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secured Client IP
A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the ZyXEL Device using this service.
SNMP
Configuration
Get Community
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and
allows all requests.
Set Community
Enter the Set community, which is the password for incoming Set requests
from the management station. The default is public and allows all requests.
Trap Community
Type the trap community, which is the password sent with each trap to the
SNMP manager. The default is public and allows all requests.
Trap Destination
Type the IP address of the station to send your SNMP traps to.
Apply
Click Apply to save your customized settings and exit this screen.
Cancel
Click Cancel to begin configuring this screen afresh.