ZyXEL Communications P-793H User Manual

 Chapter 15 Remote Management Configuration

P-793H User’s Guide

See 

 for background information. Use this screen to change your 

ZyXEL Device’s SNMP settings. Click Advanced > Remote MGMT > SNMP. The screen 
appears as shown.

Figure 104   Remote MGMT > SNMP

The following table describes the labels in this screen.

Table 76   Remote MGMT > SNMP

SNMP

Port

You may change the server port number for a service if needed, however you 

must use the same port number in order to use that service for remote 

management.

Access Status

Select the interface(s) through which a computer may access the ZyXEL Device 

using this service.

Secured Client IP

A secured client is a “trusted” computer that is allowed to communicate with the 

ZyXEL Device using this service. 
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify 

to access the ZyXEL Device using this service.

SNMP 

Configuration

Get Community

Enter the Get Community, which is the password for the incoming Get and 

GetNext requests from the management station. The default is public and 

allows all requests.

Set Community

Enter the Set community, which is the password for incoming Set requests 

from the management station. The default is public and allows all requests.

Trap Community

Type the trap community, which is the password sent with each trap to the 

SNMP manager. The default is public and allows all requests.

Trap Destination

Type the IP address of the station to send your SNMP traps to.

Apply

Click Apply to save your customized settings and exit this screen. 

Cancel

Click Cancel to begin configuring this screen afresh.