Benq MX620ST Benutzerhandbuch
Operation
24
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced >
Security Settings > Change Security Settings menu after opening the OSD menu
system. Press MODE/ENTER. The message “INPUT PASSWORD” appears. Enter
the current password.
i. If the password is correct, the OSD menu returns to the Security Settings
page.
Press to highlight Power On Lock and press / to select Off. You will
not have to enter the password next time when turning on the projector.
Press to highlight Web Control Lock and press / to select Off. Now
the Web Control Lock is released and projector settings can be changed via
the Projector Network Display System.
Press to highlight Power On Lock and press / to select Off. You will
not have to enter the password next time when turning on the projector.
Press to highlight Web Control Lock and press / to select Off. Now
the Web Control Lock is released and projector settings can be changed via
the Projector Network Display System.
ii. If the password is incorrect, the password error message appears lasting for
three seconds, and the message “INPUT PASSWORD” appears for your
retry. You can press MENU/EXIT to cancel the change or try another
password.
retry. You can press MENU/EXIT to cancel the change or try another
password.
Though the password function is disabled, you need to keep the old password in hand should you ever need to
re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time. When starting up, the projector automatically searches for
the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On if you want the
projector to automatically search for the signals.
To select the source:
1.
Press SOURCE on the projector or remote
control. A source selection bar appears.
control. A source selection bar appears.
2.
Press / until your desired signal is selected
and press MODE/ENTER.
Once detected, the selected source information
will display at the corner of the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2 to
search for another signal.
and press MODE/ENTER.
Once detected, the selected source information
will display at the corner of the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2 to
search for another signal.
•
The brightness level of the projected image will change
accordingly when you switch between different input signals.
Data (graphic) "PC" presentations using mostly static images
are generally brighter than "Video" using mostly moving
images (movies).
•
The native display resolution of this projector is in a 4:3
(MS619ST/MX620ST)/16:10 (MW621ST) aspect ratio. For
best display picture results, you should select and use an input signal which outputs at this resolution. Any
other resolutions will be scaled by the projector depending upon the “aspect ratio” setting, which may
cause some image distortion or loss of picture clarity. See
for
details.
•
Firewall in the PC must be switched off to allow USB Display to work.