EIKI QXXAVC922---P Benutzerhandbuch
Chapter 4 Wired LAN configurations
Network Capture screen
Confirming the operation
Confirm that the projector has connected to the LAN properly.
1. Activate “Network Capture 4” which is installed into the computer connected to the LAN .
2. After “Searching projector” message appears, the name of the projector* appears on the Network
2. After “Searching projector” message appears, the name of the projector* appears on the Network
Projector List, then the network setting has completed properly.
When the name of the projector does not appear and error screen appears, the network has
not connected yet. Try searching again with the Search PJ button. If error screen appears again,
reconfirm the LAN setting. When the projector is set in the location separated by the router, see next
page.
reconfirm the LAN setting. When the projector is set in the location separated by the router, see next
page.
When Firewall function (Anti-virus software) is effective, network projector may not be found. In that
case, disable the Firewall function and try searching again.
✳
If the projector is named, the name will be displayed. The name can be set with the following
procedures in “6. Basic setting and operation” ➔ “Initial setting” (p48) . If the projector is not named,
IP address of the projector will be displayed.
IP address of the projector will be displayed.
Network Projector List
Search PJ button