Pitney Bowes DM525 Benutzerhandbuch

3. Drop the new tape in so that 

it feeds from the bottom of 
the roll to the right. 

The protective backing on 
the tape should be facing 
down. Pull about 10 inches 
of tape from the end of the 
roll up toward the cover and 
then loop it down into the 
slot.

4. From the “Out of Tape” or “Load Tape” screen, select Load Tape. Feed 

the tape into the slot while the tape motor is running. The machine 
automactically cuts off the excess tape.

5. Close the feed cover. 

1. If the system actually runs out of tape, the “Out of Tape” screen 

appears. 

2. Open the cover and select Unload Tape from the “Out of Tape” screen.
3. Remove any remaining tape on the tape roll. Follow steps 2 - 4 in the 

Tape still on roll procedure above.







Your mailing system displays a message telling you when your E-Z Seal® 
Solution is running low. When you receive this message, your system can 
still seal approximately 50 envelopes.

1. Open the feed cover and lift 

out the E-Z Seal® bottle.The 
bottle is located to the left of 
the tape roll.

CAUTION: Do not load a tape strip that has any pink or 
black stripes showing. This will cause the last piece of 
tape to jam in the machine which and you will need to 
place a service call. 

CAUTION:  Pitney Bowes recommends using E-Z Seal® 



Solution because it helps keep your moistener tank clean and 
improves sealing efficiency. To order E-Z Seal® Solution, 
refer to Chapter 11, Supplies and Options in this guide.