Pitney Bowes DM525 Benutzerhandbuch

1. Lift the feed cover. 
2. Push down on the moistener brush button.
3. Grasp the moistener brush assembly and pull it straight out towards 

you.

4. Clean the moistening brush by running the brush under warm water.
5. If you need to clean or replace the wick, go to Cleaning or Replacing 

the Wick procedure  below. Otherwise go to step 6.

6. Replace the existing clean moistener brush assembly, or install a new 

one by pushing the assembly back on its track until it snaps into posi-
tion.

7.  Check to make sure that the flap blade of the moistener brush assem-

bly is under (and not over) the stripper finger as shown here. 

8. Verify that the moistener brush assembly is perfectly level with the feed 

deck. 

Moistener brush button

Moistener brush assembly

Flap Blade

Stripper Finger

Feed Deck

Moistener Brush Assembly