Summit HL-630 OPC Benutzerhandbuch

Seite von 46
 
15
 
 
 
 
 
HP LaserJet 9000 
HP Part # C4583X  
OEM Stated Yield: 30,000 
 
Like the HP-4100, the 9000 cartridge also uses a 
chip. The chip in the 9000 is the same as the 4100 in 
that they only monitor usage not page counts. Each 
chip also has its own serial number which in effect 
gives the cartridge a serial number. After the OEM 
toner has been used up, the “toner low reached” code 
will be set to YES on the cartridge chip. Even after 
the cartridge is refilled, the printer display will still 
show “Toner Low” for the supplies status section of 
the menu. The main display will then show “Non HP 
Toner cartridge”. If the chip is removed, the toner 
low sensors will be disabled, and will not work again 
until a new HP cartridge is installed. New 
replacement chips are available. 
 
 
 
 
 
 
 
 
 
HP LaserJet M3027/3035/P3005 
HP Part # Q7551A, Q7551X 
OEM Stated Yield: 6,500 Q7551A, 13,000 
Q7551X 
 
The Q7551A/X cartridges use the older 2
nd
 
generation of chips.  They are identical in looks to 
the 4200/4300 series. As these machines had just 
been released at the time of this writing, no 
information on the chip function is available. Check 
with your supplier for more information. 
 
 
 
 
 
 
 
 
 
HP LaserJet M5035 
HP Part # Q7570A 
OEM Stated Yield: 15,000  
 
The M5035 uses the latest or 3
rd
 generation chip. 
They are very small, and the code is all new. They 
are identical in looks to the 5200 series. As these 
machines had just been released at the time of this 
writing, no information on the chip function or reset 
if needed is available. Check with your supplier for 
more information. 
 
 
 
HP LaserJet P2015 
HP Part # Q7553X 
OEM Stated Yield: 15,000  
 
The Q7553X cartridges use the older 2
nd
 generation 
of chips.  They are identical in looks to the 
4200/4300 series. The code is all new but as these 
machines had just been released at the time of this 
writing, no information on the chip function or reset 
if needed is available. Check with your supplier for 
more information. 
 
 
Kyocera F-1000 OPC 
Kyocera OPC Part # DK-3   
OEM Stated Yield: 10,000 
 
There is a small black fuse located on the board 
inside the cartridge. This fuse must be replaced each 
cycle by un-soldering the old and soldering in the 
new. This fuse is a special 250mA one that should 
be purchased from your supplier. The same fuse is 
used in the F-3010 OPC Cartridge.