Summit HL-630 OPC Benutzerhandbuch

 

43

 

cartridge is changed. A new fuse is not needed. 
However if the machine says change cartridge, the 
fuse is needed. Since you really have no way to 
know the state of your customer’s machine, we 
recommend that the fuse be replaced each cycle. 
These fuses are very inexpensive, and this way you 
have no worries! Starter cartridges can come with 
plastic dummy fuses. Those fuses must be replaced 
with a real fuse. The fuse is a 125V, 100mA, 
5x20mm fast acting glass type. 

 

To reset the counter in the XC-23 OPC cartridges the 
 connector on the rear of the cartridge must be 
replaced. This will clear the J7 or J8 codes.  J7= 
change copy cartridge, J8 = wrong or bad connector. 
New replacement connectors are not currently  
available, but there are companies that can repair the 
OEM connector for you.

 
 

 
The 1012 OPC cartridges look very similar to the 
5011 and 5012, but they are different and NOT 
interchangeable.  
 
There are now many different Xerox part numbers 
for these cartridges. They are interchangeable, just 
sold from different sources. A list of some of them is 
as follows: 13R8 (US), 13R10, 13R30, 113R92 
(Retail Stores), and 13R500. 

This cartridge uses an optical reset similar to the 
Panasonic 4410. The waste chamber must be 
spotless, and the float in the down position. There is 
a clear plastic bubble on top of the cartridge. This is 
what the sensor looks at and it must be spotless! The 
J7 code is triggered when the waste chamber fills up 
and moves the float into the bubble, interrupting the 
optical sensor. 
 

 
To reset the counter in the 4525 and Lexmark W820 
cartridges the connector on the rear of the cartridge 
must be replaced. This will clear the J1 or J7 codes.  
J1= Toner Out, J7 = Change cartridge. The 
connector and cartridges look similar to the N24 
style, but they are different, and NOT 
interchangeable. 

The 5011 OPC cartridges look very similar to 
the1012 and 5012, but they are different and NOT 
interchangeable.  
 
These cartridges use a reset fuse board located inside 
the connector. The connector must be un-soldered 
and a new one soldered in. Be very careful not to 
melt the cable when soldering. Make sure that you