Citizen Systems CT-S4000M Benutzerhandbuch

— 14 —

(1)

Connector Pin Configuration

1

FG

Frame Ground

2

DRAWER 1

Drawer 1 drive signal

3

DRSW

Drawer switch input

4

VDR

Drawer drive power supply

5

DRAWER 2

Drawer 2 drive signal

6

GND

Common ground on circuits

6

1

Connector used:

TM5RJ3-66 (Hirose)
or equivalent

Applicable connector:

TM3P-66P (Hirose) or
equivalent

VDR

1

2

3

4

5

6

VDR

5V

■ No output is produced while printing.

■ The cash drawers 1 and 2 cannot be driven simultaneously.

■ A solenoid used for the cash drawer should be of 24 Ω or more.  The output current

should be kept at 1A or less; otherwise, breakdown or burning could occur.

■ When used in vertical position, the printer ejects paper not to fall naturally even with

full cutting.  Be careful in using the printer built in equipment, etc.

■ Ensure that the wall on which the printer is mounted has enough strength before

installation.

■ When using in horizontal setting, avoid cutting full.  Otherwise, the cut paper may

drop into the cutter and may result in double cutting and narrow pieces of paper.  This
may cause paper jam.

(2)

Electrical characteristics
1)  Driving voltage: 24 VDC
2)  Driving current: Approx. 1A max. (shall not exceed 510

ms.)

3)  DRSW signal: Signal levels: “L” = 0 to 0.5 V, “H” = 3 to 5 V

(3)

DRSW signal
DRSW signal status can be tested with  the DLE+EOT,
GS+a, or GS+r command or
at pin 34 on the parallel interface port.

(4)

Drive Circuit (printer side)

The printer can be installed horizontally, vertically, and on the wall.
At the time of shipment, the printer is set for horizontal
installation.  To install the printer vertically or on the wall, the
following adjustments are required.

Vertical position