Citizen Systems 500 Benutzerhandbuch

20

The Quiet mode is a useful feature for further reducing print noise.

Each time the button is pressed, it will enable or disable the quiet mode.  If the indicator is lit, the
printer is running more quietly than in standard mode.

Please note that when enabled, this feature will lower the print speed.

When the printer is OFF LINE, you can adjust the paper’s position using the LF/FF key.

When pressing LF/FF, the amount of paper which is fed is determined by the current setting for
lines per inch and page length as specified by the control panel (Initial Setup mode) or your
application software.

With paper installed, pressing LF/FF once advances the paper one line.

With paper installed, holding LF/FF moves the printhead to the centre and advances the paper
to the top of the next page.

This printer has a Top of Form (TOF) function which stores the first print line position and loads
the paper to the designated position automatically. The first print line position will be stored
even after the power is turned off.

You can adjust the Top of Form position using the Micro Line Feed or Reverse Micro Line Feed
function from the Control Panel.

Do not rotate the platen knob, otherwise the printer will not be able to count the number of lines
properly.

All adjustments must be made on the first sheet of paper. If you decide to change the setting and
save it, remove the paper from the tractors, then reset and reload the paper.

If necessary, redefine the page length of the paper you are using through the Control Panel or
your application software.

To feed the paper forward or up:

While pressing and holding down the ON LINE button, press the TEAR OFF button.  This
advances the paper UP one micro line of 0.12 mm.  This is also indicated by the “TOF SET”
markings on the control panel.