Epson 500 Benutzerhandbuch

EPSON PhotoPC 500

Follow these steps to attach the optional EPSON PhotoPix

LCD monitor to the camera:

Make sure your camera is turned off. Set the PhotoPix LCD

monitor’s mode switch to the OFF position.

Pressing on the arrow on the LCD inlet cover with your

thumb, slide the cover away from the camera. (Put the

cover in a safe place.)
Position the PhotoPix LCD monitor beside the camera. The

display should be facing you.
While holding the camera with one hand, carefully slide

the LCD connector into the LCD inlet. Make sure it is

firmly in place.

LCD

Follow these steps to detach the PhotoPix LCD monitor from

the camera:
1. Turn the camera off, and set the PhotoPix LCD monitor’s

mode switch to OFF.

2. Place the camera on a flat surface with the back facing you.
3. Holding the camera with your right hand, use your left

thumb to press the release button on the LCD connector.

4. While holding down the button, carefully push the

PhotoPix LCD monitor away from the camera; do not pull

the monitor.

5. Replace the LCD inlet cover on the back of the camera.

EPSON PhotoPC 500 - 6

You can increase the camera’s storage capacity by installing a

2MB or 4MB 

memory module, as described in

this table:

See the EPSON PhotoPC 500 User’s Guide for instructions on

installing a PhotoSpan module.
You can connect the PhotoPC 500 to a standard electrical

outlet using the AC adapter (B867027) to save power when

transferring pictures to the Macintosh or PC, or operating the

camera from either system. The adapter does not charge the

camera’s batteries.
Optional 37mm video camcorder lenses or filters may also be

used for taking close-up, wide-angle and special effects

pictures. To attach a lens, screw it on the camera as shown:

Before you install a PhotoSpan memory module, make sure

you download all the pictures in the camera to the computer,

then erase them from the camera and turn the camera off.

PhotoSpan modules are sensitive to static electricity and easily

Follow these steps to install a PhotoSpan module:

1. Slide the memory module cover lock down to release the

cover.

10/96

Digital Camera