Ricoh CL3000e Benutzerhandbuch

Network Interface Board Type 3000

you removed in step

CCCC

Note

❒ After finishing installation, you

can check whether the Network
Interface Board is installed
properly. Print the configura-
tion page from the "List/Test
Print" menu. If it is installed
properly, you will see "Option
Ethernet Board" for "Controller
Option".

❒ If the Network Interface Board

is not installed properly, rein-
stall it from step

. If you cannot

install it properly even after at-
tempting reinstallation, contact
your sales or service representa-
tive.

Reference

See "Making Printer Settings
with the Control Panel" in the
Administrator Reference for
printing the configuration page.

Connecting the Network
Interface Cable to the Network

AAAA

Turn off the power

BBBB

Loop the network interface cable
and attach the ferrite core.

Note

❒ Attach two ferrite cores to the net-

work interface cable. One of them
must be attached close to the end
of the cable (on the end closet to
the printer). The other must be at-
tached approximately 45 cm (18")
(

A) apart from the end. Attach

each ferrite core with a loop.

CCCC

Attach the network interface ca-
ble to the jack on the Network In-
terface Unit.

DDDD

Connect the other end of the net-
work interface cable to the network.

EEEE

Turn on the power.

ZHBPA010E

ZHBP913E

ZHBP1470E

AresPGBOptionSetup-F_FM.book Page 37 Monday, July 29, 2002 1:12 PM