Ricoh LD124c Benutzerhandbuch
Remarks
144
7
Maintaining Your Machine
If the exposure glass, exposure glass
cover, or ADF is dirty, copy clarity
may be reduced. Clean these parts if
they are dirty.
cover, or ADF is dirty, copy clarity
may be reduced. Clean these parts if
they are dirty.
❖
❖
❖
❖ Cleaning the machine
Wipe the exposure glass cover and
ADF with a soft dry cloth. If stains
remain, wipe with a well-wrung
wet cloth, and then wipe the water
off with a dry cloth. If the stains
cannot be removed with water, use
a neutral detergent.
ADF with a soft dry cloth. If stains
remain, wipe with a well-wrung
wet cloth, and then wipe the water
off with a dry cloth. If the stains
cannot be removed with water, use
a neutral detergent.
Important
❒ Do not use chemical cleaners or or-
ganic solvents, such as thinner or
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
benzene. If such substances get in-
side the machine or melt plastic
parts, a failure might occur.
❒ Do not clean parts other than those
explicitly specified in this manual.
Other parts should be cleaned only
by your service representative.
Other parts should be cleaned only
by your service representative.
Cleaning the Exposure Glass
Clean 1 and 2.
Cleaning the Exposure Glass
Cover
Cover
Cleaning the ADF
Clean 1 and 2.
ZGGH420E
ZGJS826E
ZGJS827E
ThemisC1_AE_zentai_pre_FM.book Page 144 Thursday, July 28, 2005 2:13 PM