HP (Hewlett-Packard) LCS60 Benutzerhandbuch
LCS60 Software
Configuration Changes
A variety of commands are available to review the configuration. Commands
such as viewnets and viewhosts are available from the Config directory. Com-
mands show, types, and summary are also available to check the current confi-
guration before making configuration changes. Refer to Chapter 8 for details of
these commands.
such as viewnets and viewhosts are available from the Config directory. Com-
mands show, types, and summary are also available to check the current confi-
guration before making configuration changes. Refer to Chapter 8 for details of
these commands.
The configuration database may be changed at any time by using commands
available from the Config directory. Table 3-2 lists the configuration commands.
available from the Config directory. Table 3-2 lists the configuration commands.
Table 3-2: Configuration Commands
–
Config Directory
_ __________________________________________________________________
Configuration Command
_
__________________________________________________________________
Set the date and time
datetime
Change the node name
nodename
Choose the protocols to start when the LCS60 is rebooted
protocol
Change the default route
dftroute
Set the software key
softwarekey
Set the DNS resolver
dns
Change the SNMP configuration
snmp
Change the number of service sessions
maxsessions
Define service ports
srvports
Configure virtual IP network for PPP and SLIP
ipas
Configure IPX addresses for PPP
ipx
Configure virtual AppleTalk network for ARAP and PPP
atalkas
Add a new host to the network
addhost
Add a new network to the LCS60 configuration
addnet
Remove a host from the network
delhost
Remove a network from the LCS60 configuration
delnet
Configure the Ethernet interface
etherif
Configure subnetworks and masks
subnet
Display all hosts on a network
viewhosts
Display all configured networks
viewnets
_ __________________________________________________________________
_ __________________________________________________________________
All of these commands are entered at the Top
>
Config
>
# prompt.
Note 1:
For information on configuring multiple IP subnetworks for SLIP or
for IP over PPP, refer to Chapter 1 and to the ipas command in
Chapter 4 (PPP) or Chapter 5 (SLIP).
for IP over PPP, refer to Chapter 1 and to the ipas command in
Chapter 4 (PPP) or Chapter 5 (SLIP).
3-28
Issue 3