HP (Hewlett-Packard) LCS60 Benutzerhandbuch
Hardware
Installing the LCS60
Through Modems – console and modem optioning and cabling
Through StarKeeper II NMS – check the console and LCS60 connec-
tions to the data switch network and the related data switch confi-
guration.
tions to the data switch network and the related data switch confi-
guration.
3 . If the STATUS and RUN LEDs on the MVME197 are on solid, contact your
service representative.
Caution: Use
the exit command or ctrl-d to log off the system console, and
use a break-break sequence to disconnect. The break-break
sequence will not log you off the console, so you must first type
exit
sequence will not log you off the console, so you must first type
exit
or ctrl-d to log off.
Verify Fiber Connection
The newer CPM-HS modules have a red LED on the CPM-HS paddleboard that
indicates if the cable has not been installed correctly. If this LED is lit or if, after
configuring the CPM-HS module, the following message appears:
indicates if the cable has not been installed correctly. If this LED is lit or if, after
configuring the CPM-HS module, the following message appears:
NOTICE: DKHS0:Interface is down: TX-HANG
. . .
**********
** The CommKit Server for morse is having problems
** Please get someone to attend to it.
** The last error was:May 16 07:49:20(273)[0]dkmgr:Can’t open /dev/dk/dial0
**********
reverse the fiber cable connection on either the LCS60 or CPM-HS (whichever is
more convenient); if the machine doesn’t recover after a few minutes stop and
start dkhost
more convenient); if the machine doesn’t recover after a few minutes stop and
start dkhost
from the lcsadm interface. If the error message appears again, per-
form a diagnostic check as described in Chapter 9.
2-28
Issue 3