HP (Hewlett-Packard) LCS60 Benutzerhandbuch

Hardware

Configure the LCS60 as directed in Chapters 3 through 7.

Connections to an Ethernet LAN are made by a standard DB15 Ethernet trans-
ceiver cable.  The MVME197 processor board supports a single LAN connection.
Refer to Figure 2-7 and follow the steps in the procedure below to connect the
LAN to an LCS60.  Label all connections.  This data is required for correct confi-
guration.

1 .  When using the MVME197 interface, connect one end of the DB15 cable to

the "Ethernet 0" connector on the MVME712M module at the back of the
LCS60.

2 .  Connect the other end of the cable to the Ethernet transceiver at the LAN.

3 .  After configuring the system (as described in Chapters 3 through 7), verify

the connections as specified in Chapter 9.