Zebra Technologies 105SL Benutzerhandbuch
Configuration
Configuration and Calibration LCD Displays
11342L Rev. 8 6/4/2004
105SL User Guide
57
ZebraNet
®
Wired and Wireless Print Server LCD Displays
display only if you have the ZebraNet
PrintServer II,
10/100 PrintServer, or Wireless Print Server installed.
Important •
The Wireless Print Server is not available for 105SL printers with serial numbers
less than 6400357.
Table 7 • Print Server LCD Displays
LCD
Explanation
IP PROTOCOL
1
IP Protocol
Allows either the user (permanent) or the server (dynamic) to select the IP address. If
a dynamic option is chosen, this selection determines the method(s) by which the
print server (wired or wireless) receives the IP address from the server. For more
information, see the ZebraNet Networking: PrintServer II Installation and Users
Guide.
• Press the (+) or (–) key to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND
BOOTP, PERMANENT
Allows either the user (permanent) or the server (dynamic) to select the IP address. If
a dynamic option is chosen, this selection determines the method(s) by which the
print server (wired or wireless) receives the IP address from the server. For more
information, see the ZebraNet Networking: PrintServer II Installation and Users
Guide.
• Press the (+) or (–) key to display other choices.
Default: ALL
Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND
BOOTP, PERMANENT
IP ADDRESS
1
IP Address
This parameter allows you to select the IP address if PERMANENT was chosen in
IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the address.)
This parameter allows you to select the IP address if PERMANENT was chosen in
IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the address.)
1.
Press the (–) key to move to the next digit position.
2.
Press the (+) key to increase the value of the digit.
SUBNET MASK
1
Subnet Mask
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
This parameter selects the part of the IP address that is considered to be part of the
local network. It can be reached without going through the default gateway.
1.
Press the (–) key to move to the next digit position.
2.
Press the (+) key to increase the value of the digit.
DEFAULT
GATEWAY
1
Default Gateway
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
This parameter allows you to select the IP address that the network traffic is routed
through if the destination address is not part of the local network.
1.
Press the (–) key to move to the next digit position.
2.
Press the (+) key to increase the value of the digit.
MAC ADDRESS
2
MAC Address
This parameter cannot be changed through the front panel.
This parameter cannot be changed through the front panel.
1 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the
print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to
address 192.168.254.254.
address 192.168.254.254.
2 Appears only when the ZebraNet Wireless Print Server is installed.
3 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
3 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the
card supports LEAP.