Zebra Technologies 105SL Benutzerhandbuch
72
105SL User Guide
6/4/2004 11342L Rev. 8
Routine Maintenance
Cleaning Schedule
Cleaning Schedule
. Specific cleaning procedures are
provided on the following pages.
Cleaning the Exterior
The exterior surfaces of the printer may be cleaned with a lint-free cloth. Do not use harsh or
abrasive cleaning agents or solvents. If necessary, a mild detergent solution or desktop cleaner
may be used sparingly.
abrasive cleaning agents or solvents. If necessary, a mild detergent solution or desktop cleaner
may be used sparingly.
Table 10 • Recommended Printer Cleaning Schedule
Area
Method
Interval
Printhead
Solvent*†
Direct Thermal Print Mode:
After every roll of media (500 ft. or 50 m of
media).
After every roll of media (500 ft. or 50 m of
media).
Thermal Transfer Print Mode: After every
roll (1500 ft. or 450m) of ribbon.
roll (1500 ft. or 450m) of ribbon.
Platen roller
Solvent*
Transmissive sensor
Air blow
Black mark sensor
Air blow
Media path
Solvent*
Ribbon sensor
Air blow
Label available
sensors
sensors
Air blow
Monthly
Tear-off bar
Solvent*
As needed
Snap plate
Solvent*
Cutter
Solvent*
* Use Zebra’s Preventative Maintenance kit, part number 47362, or a solution of
90% isopropyl alcohol and 10% deionized water.
90% isopropyl alcohol and 10% deionized water.
† You may also use Zebra’s Save-a-Printhead cleaning film. This specially coated material
removes contamination buildup without damaging the printhead. Call your authorized Zebra
reseller or distributor for more information.
removes contamination buildup without damaging the printhead. Call your authorized Zebra
reseller or distributor for more information.
Caution • Use only the cleaning agents indicated. Zebra Technologies is not responsible
for any other fluids used on this printer.
for any other fluids used on this printer.
Caution • Do not use harsh or abrasive cleaning agents or solvents.