Zebra Technologies 105SL Benutzerhandbuch

74

105SL User Guide

6/4/2004 11342L Rev. 8

Cleaning Schedule

Moisten an applicator tip with a solvent containing 90% isopropyl alcohol, and wipe along 
the print elements from end to end. (The print elements are on the brown strip just behind 
the chrome strip on the printhead.) Allow a few seconds for the solvent to evaporate.

Rotate the platen roller and clean thoroughly with solvent and an applicator.

Brush/vacuum any accumulated paper lint and dust away from the rollers.

Reload the media and the ribbon (if required).

Close the printhead.

The media, ribbon, and label available sensors should be cleaned on a regular basis to ensure 
proper operation of the printer. Brush or vacuum any accumulated paper lint and dust off of 
these sensors.

Clean the snap plate to remove label adhesive or a label that has adhered to the underside of 
the snap plate.

Refer to 

. Insert a small-blade screwdriver or similar tool into the loop on the left 

side of the snap plate. Lift the snap plate.

Repeat step 1 on the right side of the snap plate.

Remove the snap plate from the printer.

Clean the snap plate with cleaning solvent and a soft cloth.

Refer to 

. To reinstall the snap plate, insert the two tabs on the bottom of the snap 

plate into the two slots of the media pathway.

Caution • Do not bend, twist, or otherwise deform the loops. If the snap plate is 
damaged in any way, a new plate may be required for proper ribbon sensing.