Zebra Technologies 105S Benutzerhandbuch
40
Zebra S-Series User’s Guide
%DQN
Note: For Serial Interface
Printers only.
The S-Series Printer, with the
RS-232 Serial Interface, uses eight
miniature switches located on the
rear of the printer above the signal
interface cable connector. The
ON/OFF positions of these
switches establish some of the
printer configuration parameters.
Bank 1 switches must be properly
positioned to establish serial data
communications with the host
computer. Thereafter, the position
of these switches should not be
changed.
RS-232 Serial Interface, uses eight
miniature switches located on the
rear of the printer above the signal
interface cable connector. The
ON/OFF positions of these
switches establish some of the
printer configuration parameters.
Bank 1 switches must be properly
positioned to establish serial data
communications with the host
computer. Thereafter, the position
of these switches should not be
changed.
Note: Parallel-interface printers
do not require these
configuration parameters,
therefore they have no
Bank 1 switches.
configuration parameters,
therefore they have no
Bank 1 switches.
If these switches are in the proper
position to match the
communication configuration of
the host computer, and the printer
is not receiving data, refer to
“RS-232 Cabling Requirements”
on page 47 and make sure the
correct interface cable is being
used.
position to match the
communication configuration of
the host computer, and the printer
is not receiving data, refer to
“RS-232 Cabling Requirements”
on page 47 and make sure the
correct interface cable is being
used.
Note: The printer is fixed at 1
stop bit, so make sure
that your host device is
also set at 1 stop bit.
that your host device is
also set at 1 stop bit.
Table 1