Toshiba satellite a20 series Benutzerhandbuch
4.11 Memory Module
4 Replacement Procedures
4.11 Memory Module
Removing a Memory Module
To remove a memory module, make sure the computer is in boot mode and powered off,
follow the steps below and refer to figures 4-18.
follow the steps below and refer to figures 4-18.
CAUTION: Do not try to remove a memory module with the computer turned on. The
computer or the memory might be damaged.
computer or the memory might be damaged.
CAUTION: Do not touch the connectors on the memory module(s) or on the computer.
Debris on the connectors may cause memory access problems.
Debris on the connectors may cause memory access problems.
1. Turn up the insulator covering the memory slots.
2. Press out on two latches. One end of the memory module will pop up.
3. Grasp the memory module and pull it out to remove the memory module from PJ1400
(Slot A) or PJ1401 (Slot B) on the system board.
Memory module
Insulator
Two latches
Memory slot A
Memory slot B
Figure 4-18 Removing the Memory module
Satellite A20 Maintenance Manual (960-444)
4-35