Toshiba 960-809 Benutzerhandbuch

The computer’s HDD is formatted using the DOS FORMAT program or the physical format 
program of the test program. To format the HDD, start with Check 1 below and perform the 
other steps as required. 

Refer to the DOS Manual for the operation of DOS. For the format by the test program, refer 
to the Chapter 3. 

Check 1  Format the 2.5” HDD using DOS FORMAT command. Type as FORMAT C: 

/S/U.  

If the 2.5” HDD can not be formatted, perform Check 2. 

Check 2  Using the DOS FDISK command, set the 2.5” HDD partition. If the partition is not 

set, go to Check 3. If it is set, format the 2.5” HDD using MS-DOS FORMAT 
command. 

Check 3  Using the Diagnostic Disk, format the 2.5” HDD with a format option (physical 

format). If HDD is formatted, set the 2.5” HDD partition using DOS FDISK 
command.  

If you cannot format the 2.5” HDD using the Tests and Diagnostic program, go to 
Procedure 4.