Nortel Networks BCM1000 Benutzerhandbuch
80
Chapter 6 Installing the BCM1000e (expansion unit)
N0008587 01
3
Fasten the bracket to the BCM1000e using the four supplied screws.
4
Repeat steps 2 and 3 on the other side, with the second bracket.
Attaching the BCM1000e to the rack
The mounting brackets you attached to the BCM1000e correspond with mounting holes located on
the equipment rack.
the equipment rack.
1
Determine the location in the rack you want to install the BCM1000e.
2
Position the unit in the rack. Refer to
3
Align the holes in the rack mounting bracket with the holes in the rails.
4
Fasten the rack mounting brackets to the equipment rack using four screws.
Figure 33 Fasten the BCM1000e to the equipment rack
Caution:
Use only the screws that came with the bracket. Using other screws can damage
the equipment.
Note:
Rack mount bracket
The BCM1000e rack mount bracket has an additional set of holes that allows you to
install the brackets so that the unit sits flush with the BCM1000 in an equipment rack
where space is limited.
install the brackets so that the unit sits flush with the BCM1000 in an equipment rack
where space is limited.
Note:
You must supply your own screws to attach the BCM1000e to the rack.