Nortel Networks BCM1000 Benutzerhandbuch
Chapter 6 Installing the BCM1000e (expansion unit)
81
Installation and Maintenance Guide
Installing the BCM1000e on the wall
The BCM1000e must be installed close enough to the BCM1000 that the 5 m (16 ft.) cable
between the unit and the BCM1000 can be connected without stress on the cable.
between the unit and the BCM1000 can be connected without stress on the cable.
Required equipment:
•
a wall mounting bracket (supplied with the unit)
•
two #10 x 2.5 cm (#10 x 1 in.) round head wood screws
•
a plywood backboard 2 cm (3/4 in.) thick
Follow these steps to mount the BCM1000e on wall:
1
Install the 2 cm (3/4 in.) plywood backboard on the wall.
2
Choose a location on the backboard that is level and leaves enough space on the sides
(23 cm or 9 in.) to insert and remove the media bay modules.
(23 cm or 9 in.) to insert and remove the media bay modules.
3
Use the slotted holes on the wall mounting bracket to mark the location for the two mounting
screws.
screws.
4
Screw two #10 x 2.5 cm (#10 x 1 in.) screws into the backboard, leaving 6 mm (1/4 in.) of the
two screws showing.
two screws showing.
5
Align the screw holes between the unit and the wall mounting bracket.
6
Fasten the wall mounting bracket using four screws. Refer to
Figure 34 Attaching the wall mounting bracket to the BCM1000e
Caution:
for acceptable environmental
conditions before selecting a location for the BCM1000e.
Note:
If the backboard for the BCM1000 has enough room for the BCM1000e, you do
not require a second backboard.