Nortel Networks BCM1000 Benutzerhandbuch
118
Chapter 9 Starting the system
N0008587 01
Checking power and wiring
The Business Communications Manager system is a global product. Therefore, you must ensure
that the power supply is correct for your location.
that the power supply is correct for your location.
•
2.0 BCM1000 hardware has a standard power supply which requires manual adjustment for
the voltage by setting a switch located on the face of the power supply.
the voltage by setting a switch located on the face of the power supply.
•
2.5 BCM1000 hardware has a standard power supplies and redundant power supplies which
adjust automatically to the required voltage.
adjust automatically to the required voltage.
Follow this procedure to check the voltage and wiring, and power up the system:
1
Check all wiring before connecting power to the BCM1000 units.
2
Connect the BCM1000 power cord to an electrical outlet that is a non-switchable, third wire
ground ac outlet.
ground ac outlet.
If you use a power bar, plug the power cords into the power bar and connect the power bar to
the ac outlet.
the ac outlet.
3
Connect the BCM1000e power cord to an electrical outlet that is a non-switchable, third wire
ground ac outlet.
ground ac outlet.
Warning:
Connecting power
Always connect power to the BCM1000 and BCM1000e, if there is one, before you
reconnect the cabling to the front of the units.
reconnect the cabling to the front of the units.
Danger:
Do not fasten power supply cords.
Do not fasten the BCM1000 or BCM1000e power supply cords to any building surface.