Nortel Networks BCM1000 Benutzerhandbuch
Chapter 9 Starting the system 119
Installation and Maintenance Guide
Checking system power and status
After you connect power to the BCM1000, the Power LED on the front of the base unit and
expansion unit lights. Refer to
expansion unit lights. Refer to
. Once the system services have reactivated, the Status
LED turns solid green.
Figure 47 LEDs confirm that BCM1000 is active
describes the possible operating states of the LEDs on the front of the BCM1000. The
BCM1000e has both a power and a status LED, which provide the same indicators as for the base
unit.
unit.
Note:
During system initialization, the system performs diagnostics on the hardware
configuration size and installation. If the power fails, system data remains in memory.
Table 28
BCM1000 LED states
LED
Label
Label
Description
Green LED On
Green LED Flash
Red LED On
(Only)
(Only)
Green LED Off
Indicates state of
system power.
system power.
OK
N/A
a minimum of 1
PS needs
attention
PS needs
attention
N/A
Indicates access to
the system disk drive
the system disk drive
indicates heavy
activity to the disk
drive
activity to the disk
drive
N/A
N/A
N/A
Indicates condition of
system status
system status
all monitored
services are
functioning
services are
functioning
in startup/
shutodown mode
shutodown mode
N/A
not all services are
working
working
1
PCI Device/
WAN Port #1
WAN Port #1
Device is present
and the driver is
active
and the driver is
active
driver is not running N/A
Device is not
present.
present.
2
PCI Device/
WAN Port #2
WAN Port #2
Device is present
and the driver is
active
and the driver is
active
driver is not running N/A
Device is not
present.
present.
3
PCI Device
Device is present
and the driver is
active
and the driver is
active
driver is not running N/A
Device is not
present.
present.
power/status
These two LEDs are solid green
These two LEDs are solid green