Nortel Networks BCM1000 Benutzerhandbuch
208 Chapter 18 Replacing a power supply
N0008587 01
8
Monitor the power LED. Refer to
.
The Business Communications Manager system starts up when you connect the ac power
cord. This takes several minutes to complete.
cord. This takes several minutes to complete.
Upgrading to a redundant power supply
The redundant power supply allows you to change a failed power supply without turning off the
system. You can add a redundant power supply to a BCM1000 currently equipped with a standard
power supply.
system. You can add a redundant power supply to a BCM1000 currently equipped with a standard
power supply.
provides an overview of the steps required to upgrade your system from a standard
power supply to a redundant power supply module.
Figure 115 Process Map: Upgrading to a redundant power supply
Table 43 Power supply LED
LED
Label
Label
Description
Green
LED On
LED On
Green
LED Flash Red LED On (Only)
LED Flash Red LED On (Only)
Green
LED Off
LED Off
Indicates state of system power. OK
N/A
at least one power supply
requires attention*
requires attention*
N/A
*Older models may not have a
Red LED
Red LED
Shut the system
down
into
power supply
housing
Set up unit for
maintenance