IBM Partner Pavilion BMD00082 Benutzerhandbuch
SmartConnect User’s Guide
80
Chapter 6: Configuring Switch Access
BMD00082, February 2009
Configuring the SCP Administrator Password
To configure the SCP Administrator password, first connect to the switch via the management
system. For security reasons, the scpadm password may only be configured when connected
through the management system.
system. For security reasons, the scpadm password may only be configured when connected
through the management system.
To configure the password, enter the following command via the CLI. At factory default set-
tings, the current SCP administrator password is PASSWORD.
tings, the current SCP administrator password is PASSWORD.
Using SSH and SCP Client Commands
This section shows the format for using some client commands. For the examples below, the IP
address of the switch is 205.178.15.100, the IP address of the management system is
205.178.15.157, and 1022 as the SSH port number.
address of the switch is 205.178.15.100, the IP address of the management system is
205.178.15.157, and 1022 as the SSH port number.
To Log In to the Switch:
Syntax:
Example:
>>
/cfg/sys/sshd/scpadm
Changing SCP-only Administrator password; validation required...
Enter current administrator password:
<password>
Enter new SCP-only administrator password:
<new password>
Re-enter new SCP-only administrator password:
<new password>
New SCP-only administrator password accepted.
ssh -1
<username> <switch IP address>
or
ssh
-p
<SSH port number>
-1
<username> <Advanced MM IP address>
>> #
ssh -1 scpadmin205.178.15.100
or
>> #
ssh -p 1022 -1 scpadmin@205.178.15.157