Juniper Networks EX8208 Benutzerhandbuch
Figure 74: Connecting an EX Series Switch Directly to a Management
Console
Console
g020570
Laptop CPU
To Console port
(on the switch)
Related Topics
•
•
•
Connecting an EX Series Switch to a Modem
You can connect an EX Series switch to a modem through the console port on the switch.
Before you connect the switch to a modem:
•
Perform the initial setup and configuration of the switch. See “Connecting and
Configuring an EX Series Switch (CLI Procedure)” on page 190 or “Connecting and
Configuring an EX Series Switch (J-Web Procedure)” on page 192.
Configuring an EX Series Switch (CLI Procedure)” on page 190 or “Connecting and
Configuring an EX Series Switch (J-Web Procedure)” on page 192.
Ensure that you have the following parts available before you begin to connect the switch
to the modem:
to the modem:
•
A modem (not provided)
•
A desktop or notebook computer (not provided)
•
An RJ-45 to DB-9 adapter and an Ethernet cable (provided)
•
A phone cable (not provided)
•
If your computer does not have a DB-9 male connector pin, a USB to DB-9 male adapter
(not provided)
(not provided)
•
An adapter to connect the RS-232 DB-25 connector on the modem to the RJ-45 to
DB-9 adapter on the switch (not provided)
DB-9 adapter on the switch (not provided)
This topic describes:
Setting the Serial Console Speed for the Switch
Before you can connect the switch to a modem, the switch’s serial console speed must
be set to 115200 baud.
be set to 115200 baud.
183
Copyright © 2010, Juniper Networks, Inc.
Chapter 10: Connecting the Switch