Netgear L3 Benutzerhandbuch

7-26

Switching Commands

This command displays port information.

The physical slot and physical port.

If not blank, this field indicates that this port is a special type of 
port. The possible values are: 

Mon - this port is a monitoring port. Look at the Port Monitoring 
screens to find out more information. 

Lag - this port is a member of a Lag. Look at the Lag screens to 
find out more information. 

Probe - this port is a probe port. Look at the Port Mirroring 
screens to find out more information.

Selects the Port control administration state. The port must be 
enabled in order for it to be allowed into the network. - May be 
enabled or disabled by selecting the corresponding line on the 
pull-down entry field. The factory default is enabled. 

Selects the desired port speed and duplex mode. If auto-negotia-
tion support is selected, then the duplex mode and speed will be 
set from the auto-negotiation process. Note that the port's maxi-
mum capability (full duplex -100M) will be advertised. Other-
wise, this object will determine the port's duplex mode and 
transmission rate. The factory default is Auto. 

Indicates the port speed and duplex mode. 

Indicates whether the Link is up or down. 

This object determines whether or not to send a trap when link 
status changes. The factory default is enabled. 

Displays whether LACP is enabled or disabled on this port.

This command enables or disables a port.