3com WX3000 Benutzerhandbuch
3-10
To do...
Use the command...
Remarks
Configure RIP to
unicast RIP packets
unicast RIP packets
peer ip-address
Required
When RIP runs on the link that does not
support broadcast or multicast, you must
configure RIP to unicast RIP packets.
support broadcast or multicast, you must
configure RIP to unicast RIP packets.
Displaying and Maintaining RIP Configuration
To do...
Use the command...
Remarks
Display the current RIP running status and
configuration information
configuration information
display rip
Display RIP interface information
display rip interface
Display RIP routing information
display rip routing
Available in any
view
view
Reset the system configuration related to RIP
reset
Available in RIP
view
view
RIP Configuration Example
Network requirements
A small-sized company requires that any two nodes in its small office network communicate with each
other, and that the network devices automatically adapt themselves to any topology change so as to
reduce the work of manual maintenance.
In this case, RIP can implement communication between any two nodes.
According to the network requirements, the network topology is designed as shown in
Figure 3-1 Network diagram for RIP configuration
Device Interface IP
address
Device Interface IP
address
Switch A
Vlan-int1
110.11.2.1/24
Switch B
Vlan-int1
110.11.2.2/24
Vlan-int2 155.10.1.1/24
Vlan-int3 196.38.165.1/24
Switch
C
Vlan-int1
110.11.2.3/24
Vlan-int4
117.102.0.1/16