3com WX3000 Manuel D’Utilisation

 

3-10 

Configure RIP to 
unicast RIP packets 

peer ip-address 

Required 

When RIP runs on the link that does not 
support broadcast or multicast, you must 
configure RIP to unicast RIP packets. 

 

Display the current RIP running status and 
configuration information 

display rip 

Display RIP interface information  

Display RIP routing information 

Available in any 
view 

Reset the system configuration related to RIP 

Available in RIP 
view 

 

A small-sized company requires that any two nodes in its small office network communicate with each 

other, and that the network devices automatically adapt themselves to any topology change so as to 

reduce the work of manual maintenance. 

In this case, RIP can implement communication between any two nodes. 

According to the network requirements, the network topology is designed as shown in 

Figure 3-1 Network diagram for RIP configuration 

 

Device  Interface IP 

address 

Device  Interface IP 

address 

Switch A 

Vlan-int1 

110.11.2.1/24 

Switch B 

Vlan-int1 

110.11.2.2/24 

 

Vlan-int2 155.10.1.1/24 

 

Vlan-int3 196.38.165.1/24 

Switch 

C 

Vlan-int1 

110.11.2.3/24 

   

 Vlan-int4 

117.102.0.1/16