Enterasys Networks D2G124-12P Benutzerhandbuch
Creating Diffserv Classes and Matching Conditions
D-Series CLI Reference 8-3
Creating Diffserv Classes and Matching Conditions
Purpose
To review, create, and configure Diffserv classes and matching conditions.
Commands
The commands used to review, create, and configure Diffserv classes and matching conditions are
listed below and described in the associated section as shown.
listed below and described in the associated section as shown.
show diffserv info
Use this command to display general Diffserv status information.
Syntax
show diffserv info
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display general Diffserv status information:
D2(rw)->show diffserv info
DiffServ Admin Mode............................ Enable
Class Table Size Current/Max................... 0 / 25
Class Rule Table Size Current/Max.............. 0 / 150
Policy Table Size Current/Max.................. 0 / 12
Policy Instance Table Size Current/Max......... 0 / 120
Policy Attribute Table Size Current/Max........ 0 / 120
Service Table Size Current/Max................. 0 / 48
Class Table Size Current/Max................... 0 / 25
Class Rule Table Size Current/Max.............. 0 / 150
Policy Table Size Current/Max.................. 0 / 12
Policy Instance Table Size Current/Max......... 0 / 120
Policy Attribute Table Size Current/Max........ 0 / 120
Service Table Size Current/Max................. 0 / 48
For information about...
Refer to page...
show diffserv info
show diffserv class
set diffserv class create
set diffserv class delete
set diffserv class match
set diffserv class rename