Enterasys Networks D2G124-12P Benutzerhandbuch
clear license
2-30 Basic Configuration
Usage
Licenses can be displayed, applied, and cleared only with the license commands described in this
chapter. General configuration commands such as show config or clear config do not affect
licenses.
chapter. General configuration commands such as show config or clear config do not affect
licenses.
Example
This example shows how to display license key information.
D2(ro)->show license
key: INCREMENT D2Policy 2006.0728 permanent 31173CAC6495 045100039001
status: Active
key: INCREMENT D2Policy 2006.0728 permanent 31173CAC6495 045100039001
status: Active
clear license
Use this command to clear the license key settings..
Syntax
clear license featureId feature
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear the D2 Policy licensed feature :
D2(rw)->clear license featureId D2Policy
Configuring System Power and Power over Ethernet (PoE)
Purpose
To review and set system power and PoE parameters, including the power available to the system,
the usage threshold for each module, whether or not SNMP trap messages will be sent when
power status changes, and per‐port PoE settings.
the usage threshold for each module, whether or not SNMP trap messages will be sent when
power status changes, and per‐port PoE settings.
featureID feature
The name of the feature being cleared.
Important Notice
Some commands in this section apply only to PoE-equipped D-Series devices. Consult the Installation Guide
shipped with your product to determine if it is PoE-equipped.
shipped with your product to determine if it is PoE-equipped.