Enterasys Networks 6H3xx Betriebsanweisung
General Configuration Screen
Module Configuration Menu Screens
5-17
3. Use the arrow keys to highlight SAVE at the bottom of the screen.
4. Press ENTER. The warning shown in
displays.
Figure 5-6
Clear NVRAM Warning
5. To clear the NVRAM, use the arrow keys to select YES and press ENTER. The message
“CLEARING NVRAM. REBOOT IN PROGRESS...” displays. The switch module clears
NVRAM and reboots. All user-entered parameters default to factory default settings.
NVRAM and reboots. All user-entered parameters default to factory default settings.
5.2.12 Enabling/Disabling IP Fragmentation
To enable or disable IP Fragmentation, proceed as follows:
1. Use the arrow keys to highlight the IP Fragmentation field.
2. Press the SPACE bar to choose either ENABLED or DISABLED.
3. Use the arrow keys to highlight the SAVE command.
4. Press ENTER. The message “SAVED OK” displays.
CAUTION: If the switch module is being bridged to an FDDI ring (for example, via an
optional HSIM-F6), IP Fragmentation should be enabled. If it is disabled, all FDDI
frames that exceed the maximum Ethernet frame size are discarded.
optional HSIM-F6), IP Fragmentation should be enabled. If it is disabled, all FDDI
frames that exceed the maximum Ethernet frame size are discarded.
WARNING
17426_1
YOU HAVE ELECTED TO CLEAR NVRAM. THIS WILL CLEAR
ALL SYSTEM DEFAULTS INCLUDING BUT NOT LIMITED TO
IP ADDRESS, INTERFACE CONFIGURATION, AND COM PORT
CONFIGURATION, THEN REBOOT THIS DEVICE.
ARE YOU SURE YOU WANT TO CLEAR NVRAM?
ALL SYSTEM DEFAULTS INCLUDING BUT NOT LIMITED TO
IP ADDRESS, INTERFACE CONFIGURATION, AND COM PORT
CONFIGURATION, THEN REBOOT THIS DEVICE.
ARE YOU SURE YOU WANT TO CLEAR NVRAM?
YES
NO