Enterasys Networks 6H3xx Betriebsanweisung

To configure a VLAN port, proceed as follows:

1. Use the arrow keys to highlight the PVID field.

2. Type the PVID number to be assigned to the port. 

3. Use the arrow keys to highlight the Port Mode field.

4. Press the SPACE bar to select appropriate Port Mode: HYBRID, 1Q TRUNK, or 1D TRUNK. 

The default is HYBRID.

5. Use the arrow keys to highlight the port’s Acceptable Frame Types field.

6. Press the SPACE bar to toggle the field to the correct setting: ADMIT ALL FRAMES or 

ADMIT TAGGED FRAMES ONLY. 

7. Use the arrow keys to highlight the port’s Ingress Filtering field. 

8. Press the SPACE bar to toggle the field to the correct setting: ENABLED or DISABLED. This 

will either enable or disable the filtering set in the Acceptable Frame Types field in step 5.

9. Use the arrow keys to highlight the port’s GVRP Status field. 

10.Press the SPACE bar to toggle the field to the correct setting: ENABLED or DISABLED. 

11.To configure more than one port, repeat 

 through 

 to save your 

settings.

12.Use the arrow keys to highlight the SAVE command at the bottom of the screen.

13.Press ENTER. The message “SAVED OK” displays and all settings are saved.

To perform the following:

Display the VLAN ID (VID), Protocol Classification, and Description of each classification of 
the current entries.

NOTE: In the following steps, you only need to step to the fields that you are going to 
change.