Enterasys Networks 6H3xx Betriebsanweisung

To assign a Classification to a VID, proceed as follows:

1. Use the arrow keys to highlight the VID (VLAN identification) field.

2. Type in the appropriate VID. Press ENTER.

3. Use the arrow keys to highlight the Classification field.

4. Press the SPACE bar to step to the appropriate Classification. 

 lists the 

subclassification associated with each Classification (examples of classifications: 
Ethernet II Type, 802.3 SAP, IP TOS, IP Protocol Type, etc.).

5. Use the arrow keys to highlight the subclassification field to the immediate right of the 

Classification field. The name of the field changes depending on the selected Classification, as 
shown in 

 (examples of subclassification: Ethernet II Type, SSAP/DSAP (803.2), Type 

of Service, IP Protocol Type, etc.).

6. Press the SPACE bar to step to the appropriate protocol. In some cases, there is only one 

selection and a value needs to be entered. This is indicated by bold zeros. 

possible selections associated with each subclassification (examples: IPX, AppleTalk,
NetBIOS, Banyan Vines, 000.000.000.000, 0x00000000, etc.).

7. In some cases, a selection in the subclassification field requires a value to be entered in a third 

field to the right of the subclassification field. If so, use the arrow keys to highlight that third 
field and type in the appropriate value. Otherwise, go to 

.

8. Use the arrow keys to highlight the ADD command field.

9. Press ENTER to save the VID and Classification settings. After a brief delay, the Classification 

Rule will display in the top half of the screen.

NOTE: It is strongly recommended that you read 

 for more information 

concerning classification before configuring the switch module. Incorrect configuration 
will affect network operation.

NOTE: After creating a classification rule you must assign it to the appropriate ports 
using the Protocol Port Configuration screen described in