Fujitsu FX1008MT Benutzerhandbuch
DIP Switch Settings
The factory default settings are as follows:
1 2 3 4 5 6 7 8
ON
OFF
(*Note: the indicates the switch position)
DIP Switch Functions
SW
Function
ON state / OFF state
1
Hot Key Mode: <Ctrl>+<Alt>+<Shift> ON: enabled / OFF: disabled
2
Hot Key Mode: Double <Ctrl>
ON: enabled / OFF: disabled
3
Hot Key Mode: Double <Scroll Lock>
ON: enabled / OFF: disabled
4
Country Setting bit 1
(see following table)
5
Country Setting bit 2
( “ )
6
Country Setting bit 3
( “ )
7
Country Setting bit 4
( “ )
8
Power Mode Setting
ON:
the switch device is always ON.
OFF:
the switch device turns ON if any connected host
is turned ON.
is turned ON.
The country code (language) settings are as follows:
Country Setting
SW4 SW5 SW6 SW7
Japan
ON ON ON ON
US
ON ON ON OFF
UK
ON ON OFF ON
German
ON ON OFF OFF
French
ON OFF ON ON
Spanish
ON OFF ON OFF
Swedish
ON OFF OFF ON
Switching the KVM While Using SUN Hosts
When using only Sun hosts, you can change KVM switches without turning off the power to a Sun
host. Disconnect the connector from the KVM side only when changing them. Leave the host side
connectors attached.
Note: When using PC/AT hosts, if all connections are USB type, you can similarly change KVM
switches without turning off the power to the hosts.
host. Disconnect the connector from the KVM side only when changing them. Leave the host side
connectors attached.
Note: When using PC/AT hosts, if all connections are USB type, you can similarly change KVM
switches without turning off the power to the hosts.
8