Hearth & Home Technologies WSK300 Benutzerhandbuch

2

Risk of damage to control.

Ensure wires are placed into correct color coded terminals 
without touching other wires.

•  Incorrect placement or crossed wires may damage wall 

control.

1.  Install the solenoid  (see Figure 1).

2.  Remove screw and knob from variable regulator and 

discard. Unscrew nut from regulator and discard.

3.   Remove the bag containing a washer and blue and 

red plungers from the side of the fl ame control sole-
noid. Place washer on fl ame control solenoid.

4.  Insert correct plunger (blue - natural gas, red - pro-

pane) into the fl ame control solenoid. Thread the 
fl ame control solenoid with correct plunger into the 
thread hole in the variable regulator. Turn solenoid 
into valve approximately two full turns. Do not tighten 
or damage may occur.

5.  Connect two pin molex connector from the fl ame con-

trol solenoid to the fi rst two pin molex plug on the con-
trol box, as noted on the control module label.

6.  Refer to Setting Flame Height/Manifold Pressure in-

structions on page 4.

6.  Place front cover plate onto wall control.

7.  Place bottom of wall control faceplate into grooves. Snap 

upper faceplate into place.