LevelOne GSW-0890 Benutzerhandbuch

 

18

There are three ways to configure and monitor the switch through the 

switch’s Ethernet port. They are CLI, Web browser and SNMP manager. The user 
interface for the last one is NMS dependent and does not cover here. We just 
introduce the first two types of management interface. 

 
 
 
 
 

 

 

 
 
 
 
 
 
 

 

• Managing through Ethernet port 
 

Before you communicate with the switch, you have to finish first  the            

configuration of the IP address or to know the IP address of the switch. Then, 
follow the procedures listed below. 
 

1.  Set up a physical path between the configured the switch and a PC by a 

qualified UTP Cat. 5 cable with RJ-45 connector. 

Note: If PC directly connects to the switch, you have to setup the same 
subnet mask between them. But, subnet mask may be different for the PC 
in the remote site. Please refer to Fig. 2-9 about the switch’s default IP 
address information. 

2.  Run CLI or web browser and follow the menu. Please refer to Chapter 3 

and Chapter 4. 

GSW-0890 L2 Managed Switch  
Default IP Setting: 
IP = 192.168.1.1 
Subnet Mask = 255.255.255.0 
Default Gateway = 192.168.1.254 

 

Assign a reasonable IP address, 
For example: 
IP = 192.168.1.100 
Subnet Mask = 255.255.255.0 
Default Gateway = 192.168.1.254 

Fig. 2-9 

    Ethernet LAN