Advantech EKI-7758F Benutzerhandbuch
EKI-7758F User Manual 26
After you have logged in to the system, you will see a command prompt. To enter CLI management interface,
type in “enable” command.
type in “enable” command.
Figure 3.4: Command Line Interface
The following table lists the CLI commands and description.
3.1.1 Commands
Level
Table 3.1: Command Level
Modes
Access Method
Prompt
Exit Method
About This Model
User EXEC
Begin a session with
your switch.
your switch.
switch>
Enter logout or quit.
The user commands available
at
the user level are a subset of
those available at the
privileged level.
Use this mode to
•
at
the user level are a subset of
those available at the
privileged level.
Use this mode to
•
Perform basic tests.
•
Display system information.
Privileged
EXEC
EXEC
Enter the enable
command while in
user EXEC mode.
command while in
user EXEC mode.
switch#
Enter disable to exit.
The privileged command is
advance mode
Privileged this mode to
•
advance mode
Privileged this mode to
•
Display advance function
status
•
•
save configures
Global
configuration
configuration
Enter the configure
command while in
privileged EXEC
mode.
command while in
privileged EXEC
mode.
switch(config)#
To exit to privileged
EXEC mode, enter
exit
EXEC mode, enter
exit
or end
Use this mode to configure
parameters that apply to your
switch as a whole.
parameters that apply to your
switch as a whole.
VLAN database
Enter the vlan
database
database
command
while in privileged
EXEC mode.
EXEC mode.
switch(vlan)#
To exit to user EXEC
mode, enter
exit
mode, enter
exit
.
Use this mode to configure
VLAN-specific parameters.
VLAN-specific parameters.
Interface
configuration
configuration
Enter the interface
command (with a
specific interface)
while in global
configuration mode
command (with a
specific interface)
while in global
configuration mode
switch(config-if)#
To exit to global
configuration mode,
enter exit.
To exist to privileged
EXEC mode, or end.
configuration mode,
enter exit.
To exist to privileged
EXEC mode, or end.
Use this mode to configure
parameters for the switch and
Ethernet ports.
parameters for the switch and
Ethernet ports.