Sun Microsystems X4100 Benutzerhandbuch

Sun Fire X4100/X4100 M2 and X4200/X4200 M2 Servers Installation Guide • May 2007

Installing the Server Into the Slide Rail
Assemblies

Use this procedure to install the server chassis, with mounting brackets, into the
slide-rail assemblies that are mounted to the rack.

Caution –

This procedure requires a minimum of two people because of the weight

of the server. Attempting this procedure alone could result in equipment damage or
personal injury.

1. Push the slide-rails into the slide-rail assemblies as far as possible.

2. Raise the server so that the rear ends of the mounting brackets are aligned with

the slide-rail assemblies that are mounted in the equipment rack. See

3. Insert the mounting brackets into the slide-rails, then push the server into the

rack until the mounting brackets encounter the slide-rail stops (approximately 12
inches or 30 cm).

FIGURE 1-4

Inserting the Server With Mounting Brackets Into the Slide-Rails

Slide-rail

assembly

mounted on
rack post

Mounting bracket
inserted into

slide-rail

Slide-rail
release button

Slide-rail locks